3 inch pump
Fits most power shift tractors
& industrial applications
$605 exchange
$300 core charge
4 inch pump
Most front wheel assist applications
$700 exchange
$300 core charge
Tandem pump
$950 exchange
$300 core charge
Duel inlet 3 inch pump
$605 exchange
$150 core charge
4 inch pump
Fits 410 or 310B
$810 exchange
$300 core charge
Fits 410C, 510C, early 410D
$1,490 exchange
$500 core charge
* undersized
Keyed shaft pump
Fits most smaller tractors
$520 exchange
$150 core charge
(bleed off line)
Fits later model tractors with syncro or quad range transmission
$595 exchange
$150 core charge
Fits early model 3010
& 4010 without bleed off line
$595 exchange
$150 core charge
$2,395 exchange
$500 core charge
* undersized
With charge pump
$950 exchange
$300 core charge
Services
Kin-Tec Industries is a leading re-manufacturer of John Deere radial hydraulic pumps.
We completely disassemble each unit and magna-flux it to ensure there are no cracks in the housing. Then, we thoroughly clean, reassemble, and test the part for performance.
Our tolerances on parts exceeds original specs. Rest assured that you will receive the absolute best product on the market for your money. Also, we take pride in repairing parts that our competitors would say are non-repairable.
In-House Machine Shop
We have a complete in-house machine shop. This means that your hydraulic needs and repairs can be handled quickly, efficiently and more cost effectively!
New parts such as pistons, shafts, and bearing races are Parkerized for maximum longevity. Our in house machine shop over sizes the housing if needed.
Warranty
Our work comes with a standard 90 day warranty on parts, which is the same warranty you receive with a brand new part. This warranty even includes the RE33603 and RE33468.
WE NOW UNDERSIZE THE RE33603 AND RE33468 PUMP AND SLEEVE EACH BORE. This allows the pump to last longer than the original new pump. You will not notice any difference in the flow performance but the new design will keep the pump at a cooler working temperature which allows it to last much longer.
On our quality work, the piston to sleeve tolerance is less than .001! This assures an efficient and long lasting bore. It also removes the stress from the rest of the hydraulic system, translating to a longer lasting pump!